Skip to content
Cold Steel RentalsFind a machine and dates

How to read a telehandler load chart

The number in the machine name is the best case. The chart is the rule, and it is the one the machine obeys.

Every telehandler carries a load chart in the cab. It is not paperwork. It is the only statement of what the machine will actually lift, and it changes with every foot the boom goes out or down.

A machine called a ten thousand pound telehandler is rated for that with the carriage tucked in and low. Push the boom out to full reach and the same machine may be rated a fraction of it. Nothing is wrong with the machine; that is physics, and the chart is where the manufacturer wrote it down.

Reading it

Find your reach first
Horizontal distance from the front wheels to where the load must sit. Not the height. Reach is the axis that punishes you.
Then your height
Where the load has to land, measured from the ground the machine stands on rather than the ground the load leaves.
Read the zone, not the edge
The chart is drawn as zones. If your point sits on a boundary, you are in the lower zone. Round against yourself every time.
Check what the forks are carrying
The rating includes the attachment. A carriage, a jib and a bucket each have their own chart, and fitting one replaces the fork chart entirely rather than modifying it.
Level, and on its tyres or its outriggers
Charts are drawn for a specific configuration. A machine out of level is off its chart, and so is one on outriggers being read against the tyres column.

The mistake that puts machines over

Planning the lift from the machine name. Somebody books a ten thousand pound telehandler for an eight thousand pound load, gets to site, and finds the load has to go twenty five feet out to clear a foundation, where that machine is rated nothing like eight thousand pounds.

The second mistake is the jib. A truss boom raises hook height above the fork height, which is exactly why people fit one, and it drops capacity to a few hundred pounds. It is rated for straight ahead lifts only.

Tell us the weight, the height and the reach before you book and we will read it off the actual chart for the actual machine.

The two telehandlers we rent

Both carry their load chart in the cab. The specifications on each machine page state the figures the chart governs.

Questions we get asked

Where is the load chart?
In the cab, in the operator eyeline, on every machine that leaves this yard. If it is missing or unreadable, stop and call us.
Does the load chart change with a different attachment?
Yes, completely. Each attachment has its own chart and it replaces the fork chart rather than adjusting it.
Can you tell me whether my lift is within the chart?
Yes. Ring the yard with the weight, the height and the reach and we will read it off the chart for the machine you are booking.

The machines this is about

Written 12 November 2026. Rates on this page are read from the yard’s own rate book when you load it, so they are current whatever the date says.

All equipmentAsk the yard

More guides